11/12/18

BL 551433342


Hello everyone, I am back once again, this time with a diptych to show all of you. 

For this work, I felt I should finally spend some more of the creative capital I was building up with the small kinetic editions I have been doing over the last year or so. 
(has it really been years already?)


So this project pulls quite a bit of inspiration from my kinetic experiments in order to make a decidedly non kinetic, stand-alone, pair of sculptures. Some of the input for these works might be obvious to those who have been following along, however many elements from this work are also drawn from a collaboration project that is still in development, and so wont be revealed until a little later.

So there is still an air of mystery to this work as well.   


Because so much of the seed material for this work comes from a project that is still under wraps, I am going to refrain from talking about this piece too much and instead let the images do more of the work this time around. I am sure you wont mind a little less babble for once, and when I get the companion work out, I can fill in some more of the blanks then.

I certainly didn't want to wait any longer to release these images so please enjoy.






Just kidding, process wise there is still a good bit to comment on so how can I refrain. 


The color work on these was incredibly complicated. Achieving the two tone color pallet on each of these works was done using a powder coat masking process I have used only a few times before. Mostly because of the high difficulty associated with it.


Essentially the first color is applied as a powder coat resin, and then the parts are all re-machined to expose bare aluminum where the second color is desired. Then the parts are carefully (very carefully...) anodized so that only the exposed areas can be colored with the second color. 



Getting this process correct without damaging the powder coating took weeks of experimentation. So while the works are modest in size (7.5"x8"x6") they required an amount of time to produce comparable with some much larger and complicated works. 


 So ok, still a short and sweet post this time, but as usual, comments and questions are always welcome.


Meet and greet opportunity!

If You live in the North Carolina Area, I will be hangin out at the Okuma winter showcase as a special guest. I will be giving a few talks and hanging out with some of my sculpture work amongst the displays of machine tools that are far far beyond my budget as an artist, but inspiring none the less. 

Should be a lot of fun so stop by. A more official announcement will be coming shortly.